|
》 |
Independent adjustment of Max and BIAS |
 |
|
》 |
Down-opened Panel, easy for fuse replacement. |
|
》 |
VR of Max and SFS are installed in the front panel, easy for
adjustment. |
|
》 |
Multi-LED display panel makes the operating condition clear. |
|
》 |
The auxiliary powers (ACI, AC2) are independently controlled for
all models. |
|
》 |
Build-in buffering output adjustment (SFS VR), adjusting range
1~22 seconds.
(Only for the phase control products) |
|
》 |
Top & bottom shielding covers are designed for safety and
fashion out looking, also
easy for wiring installation |
|
》 |
In case of 0.5 Hz sudden power losses, system output can
switched off immediately.
Once the power is restored, the system
will buffer the output to prevent the voltage
surge for fuse burn-down. |
|
》 |
Main power is one spec. Design for 200~480VAC. |
|
》 |
Automatic power frequency detection for 50~60 Hz. No need for
selection or switch |
|
》 |
Automatic detection and display for power out-of-phase, SCR
overheating, and fuse burn-down with one set of alarm
dry
contact output. |
|
》 |
In cases of SCR overheating or fuse burn down, the system
output is stopped immediately. Once the malfunction
is
eliminated and power is restored, the system will buffer the
output to prevent the fuse burn-down. |
|
》 |
4~20mA, 1~5VDC, 2~10VDC, 0~20mA, 0~5 VDC, 0~10 VDC, Dry contact
points, etc. and all control signals are
ready to use. |
|
》 |
Triggering circuit and the main board are designed separately to
avoid the main board damage when main circuit malfunctions. |
|
》 |
Using European detachable control signal connector for easy
replacement without re-wiring installation. |
